What if I forget the Admin password for my camera?
(How do I reset my camera to factory default settings?)
Note: After a factory reset you will need to re-register the camera with mydlink. Do not unplug the power during this procedure.
Step 1: With the unit on, place a paper clip into the hole on the back on the unit labeled Reset.
Step 2: Use the paperclip to press the button inside the hole for 10 seconds and release.
Step 3: The unit will then reboot. Once the LED light on the front of the unit stops blinking, the unit is reset and all settings are restored to their defaults.
Podobné témata:
- How do I change the LAN IP address of my camera? Přečtěte si odpověď
- How do I configure motion detection on my camera? Přečtěte si odpověď
- How do I configure the audio settings (speaker and microphone) on my DCS-2136L? Přečtěte si odpověď
- How do I find the IP address of my DCS-2136L and access the web-based user interface? Přečtěte si odpověď
- How do I manually upgrade the firmware on my camera? Přečtěte si odpověď
- How do I mount my camera to the wall or ceiling? Přečtěte si odpověď
- How do I set an administrator (admin) password on my DCS-2136L? Přečtěte si odpověď
- How do I set up and install my DCS-2136L? Přečtěte si odpověď