How do I set an administrator (admin) password on my DCS-6004L?
Note: mydlink Cloud Service registration requires the admin password.
Step 1: Open a web browser and enter the IP address of your camera in the address bar (default is 192.168.0.20). If you do not know the IP address of your camera, please refer to the section entitled “How do I find the IP address of my DCS-6004L and access the web-based user interface?” in this FAQ. Press Enter.
Step 2: The username for the administrator account is admin. Enter your administrator password in the password field. If you have not changed this from the default, leave this field blank. Click OK.
Step 3: Click the Maintenance tab at the top of the page and then click Admin from the menu on the left hand side.
Step 4: To change the administrator password, enter a New Password under the Admin Password Setting section. Enter the password again in the Retype Password field to confirm.
Step 5: Click Save to save the settings.
Note: If you forget the administrator password, you will need to reset the device in order to gain access to the configuration interface.
Podobné témata:
- Jak se mohu vzdáleně připojit k mé kameře Mydlink DCS-932L? Přečtěte si odpověď
- How do I change the LAN IP address of my camera? Přečtěte si odpověď
- How do I configure Internet Explorer to allow ActiveX Controls? Přečtěte si odpověď
- Jak nastavit detekci pohybu na mé kameře DCS-932L? Přečtěte si odpověď
- How do I configure the audio settings (audio out and microphone) on my DCS-6004L? Přečtěte si odpověď
- How do I find the IP address of my DCS-6004L and access the web-based user interface? Přečtěte si odpověď
- How do I manually upgrade the firmware on my camera? Přečtěte si odpověď
- How do I mount my camera to the wall or ceiling? Přečtěte si odpověď
- How do I set up and install my DCS-6004L? Přečtěte si odpověď
- What can I do when Active X fails to install during my mydlink camera setup? Přečtěte si odpověď
- What do I do if I forget the Admin password for my camera? Přečtěte si odpověď