What if I forget the Admin password for my camera?

(How do I reset my camera to factory default settings?)

Note: After a factory reset you will need to re-register the camera with mydlink. Do not unplug the camera from the power during this procedure.

Step 1: Remove the protective cover from the rear of the unit.

Step 2: With the unit on, use a paperclip to press the button located inside the small hole on the underside of the cavity exposed by removing the protective cover.

Step 3: Press and hold the button inside the hole for 10 seconds and release.

picture

Step 4: The unit will then reboot. Once the LED light on the front of the unit turns green, the unit has been reset and all settings have been restored to their defaults.

Rank: 1.5

Ezek szintén segíthetnek:

  • How do I access my mydlink camera remotely? Válasz
  • How do I change the LAN IP address of my camera? Válasz
  • How do I configure motion detection on my camera? Válasz
  • How do I configure the audio settings (microphone) on my DCS-2330L? Válasz
  • How do I find the IP address of my DCS-2330L and access the web-based user interface? Válasz
  • How do I manually upgrade the firmware on my camera? Válasz
  • How do I mount my camera to the wall or ceiling? Válasz
  • How do I set an administrator (admin) password on my DCS-2330L? Válasz
  • How do I set up and install my DCS-2330L? Válasz
  • Which types of motion detection are available on my IP camera? Válasz