What should I do if the setup wizard can't find my device?
Please try the following:
1. Make sure you are using the latest setup wizard for your device and operating system. Latest version can be found on the support page. Please make sure that you select Setup Wizard for the correct model and version of your device.
2. The computer you are using to configure your device must be on the same network and subnet.
3. If you are setting up a ShareCenter, make sure the hard disk LED on your device is Green.
4. If you are having problems connecting your device wirelessly, it is recommended that you use a wired connection method for the initial setup of your device.
5. Temporarily turn off the antivirus and firewall protection, then go through the setup wizard again. Remember to turn your antivirus or firewall software back on when you finish using the setup wizard.
Inne pomocne materiały:
- Active X fails to install during my mydlink camera setup Przeczytaj
- Error Unable to connect to mydlink website during Setup Wizard Przeczytaj
- How do I add a mydlink-enabled device to my account if it's currently registered to another account? Przeczytaj
- How do I connect my camera wirelessly using Wi-Fi Protected Setup(WPS)? Przeczytaj
- How do I set up a mydlink-enabled Cloud Camera? Przeczytaj
- How to add 2nd camera to the same mydlink account? Przeczytaj
- I'm using the Setup Wizard for my camera, but it won't let me save the camera's password. Przeczytaj
- I'm getting error Cannot find Camera during my Mydlink camera setup Przeczytaj
- I'm getting error Unable to add this device to your mydlink account during my mydlink camera setup Przeczytaj
- What should I do if I can NOT set the device password Przeczytaj
- What should I do if I forget my mydlink-enabled products device password Przeczytaj