Note: Make sure you have a solid green light on the camerabefore trying to run the Installer. Running the IP Installer:

Step 1 Put the D-Link CD in your computer and letit autorun.

Step 2 Click on the IP Installer.

Step 3 In the IP Installer window you should nowsee the Mac address of the camera. If you do not see the Macaddress, reset the camera.

Step 4 Highlight the Mac address and click on theWizard button located on the left side of the window.

Step 5 From the Setup Window click next.

Step 6 At this point you will need to assign anIP address to your camera. ***The IP address must be in the samesubnet as your computers network adapter card i.e, 192.168.0.x. Youwill also need a subnet mask i.e, 255.255.255.0. You will not needa default gateway or DNS address at this time.

Step 7 Click Restart.

Step 8 Click ok to the message Install ok.

Step 9 You may now click on the LINK button onthe left side of the IP Installer window. This will connect youdirectly to the Web configuration page for additional changes tothe camera. If LINK does not take you to the camera configuration,launch Internet Explorer manually and enter the cameras newlyassigned IP address into the address bar.