What do I do if I forget the Admin password for my camera?
How do I reset my camera to factory default settings?
Note: After a factory reset you will need to re-register the camera with mydlink. Do not unplug the power from the device during this procedure.
Step 1: With the unit on, place a paper clip into the hole on the front on the unit labeled Reset.
Step 2: Use the paperclip to press the button inside the hole for 10 seconds and release.
Step 3: The unit will then reboot. Once the LED light on the front of the unit stops blinking, the unit is reset and all settings are restored to their defaults.
These may also help:
- How do I access my mydlink camera remotely? Read Answer
- How do I change the LAN IP address of my camera? Read Answer
- How do I configure Internet Explorer to allow ActiveX Controls? Read Answer
- How do I configure motion detection on my camera? Read Answer
- How do I configure the audio settings (audio out and microphone) on my DCS-6004L? Read Answer
- How do I find the IP address of my DCS-6004L and access the web-based user interface? Read Answer
- How do I manually upgrade the firmware on my camera? Read Answer
- How do I mount my camera to the wall or ceiling? Read Answer
- How do I set an administrator (admin) password on my DCS-6004L? Read Answer
- How do I set up and install my DCS-6004L? Read Answer
- What do I do if I forget the Admin password for my camera? Read Answer