How do I set up motion detection and recording in D-ViewCam?
Step 1: Launch D-ViewCam and click the Schedule Configuration icon.
Step 2: Select the camera(s) you want to apply the recording schedule to, create a schedule and click Configure.
Step 3: Under the Mode menu, select Record on Motion.
Step 4: Under the Original Video view, click and drag to draw a box or multiple boxes to determine the area(s) that you want to monitor for motion. You can also use the sliders to determine the Sensitivity and Frame Interval for motion detection.
Click OK to close the Encoding Options and click OK again to close Schedule Configuration.
Step 5: Click the Start Menu icon and click Start Recording Schedule.
A circle will appear in the top right corner of each camera configured for motion detection recording.
•Green = No Motion Detected
•Red= Motion Detected
These may also help:
- How do I access my mydlink camera remotely? Read Answer
- How do I change the LAN IP address of my camera? Read Answer
- What can I do when Active X fails to install during my mydlink camera setup? Read Answer
- How do I configure motion detection on my camera? Read Answer
- How do I configure the audio settings on my DCS-5020L? Read Answer
- How do I enable a new camera in D-ViewCam? Read Answer
- How do I manually upgrade the firmware on my camera? Read Answer
- How do I mount my camera to a wall or ceiling? Read Answer
- How do I reset my camera to factory default settings? Read Answer
- How do I set an administrator (admin) password on my DCS-5020L? Read Answer
- How do I set up and install my DCS-5020L? Read Answer
- How do I set up motion detection and recording in D-ViewCam? Read Answer
- How do I set up scheduled recording in D-ViewCam? Read Answer
- How many types of motion detection are available on my IP camera? Read Answer